ACDelco
ACDelco 18B80 | Rear Brake Drum
ACDelco Professional Brake Drums are constructed with G3000 SAE qualified material for structural integrity and maximum service life. They are tested to ISO/TS 16949 quality system standards and...
ACDelco Advantage Brake Drums are constructed with G3000 material for maximum service life. They are validated for balance to provide better braking performance. Chamfer angle, vane configuration, and plate thickness all follow the OE design. Also, no machining is required. ACDelco Advantage Brake Drums are ready to be installed right out of the box. ?
Bolt Circle Diameter (in) | 5 |
Bolt Circle Diameter (mm) | 127 |
Bolt Hole Quantity | 5 |
Brake Surface Finish | Directional |
Center Bore Diameter (in) | 3.1 in |
Center Bore Diameter (mm) | 78.7 mm |
Cooling Fins | Yes |
FAQ - Answer 1 | No, but it is a good idea to inspect them for wear-out, cracking, leaking, etc. |
FAQ - Answer 2 | Yes, ACDelco also offers GM OE and Professional brake drums. |
FAQ - Answer 3 | No, but it is a good idea to inspect them at every tire rotation. |
FAQ - Question 1 | Do I have to replace all my brake parts when replacing my brake drums? |
FAQ - Question 2 | Does ACDelco offer other grades of brake drums? |
FAQ - Question 3 | Do I have to replace my brake drums after a certain amount of time? |
Good Maintenance Practices - Section 1 - Bullet 1 | Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations. |
Good Maintenance Practices - Section 1 - Bullet 2 | Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required. |
Good Maintenance Practices - Section 1 - Bullet 3 | Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary). |
Good Maintenance Practices - Section 1 - Header | The following inspections and maintenance procedures can help prevent potential brake problems: |
Good Maintenance Practices - Section 2 - Bullet 1 | Inspection of the brake hoses for brittleness or cracking. |
Good Maintenance Practices - Section 2 - Bullet 2 | Inspection of brake lining and pads for wear or contamination by brake fluid or grease. |
Good Maintenance Practices - Section 2 - Bullet 3 | Inspection of wheel bearings and grease seals. |
Good Maintenance Practices - Section 2 - Bullet 4 | Parking brake adjustments (as needed). |
Good Maintenance Practices - Section 2 - Header | The following should be conducted by a qualified technician: |
Height (in) | 4.72 |
Includes ABS Sensor Ring | No |
Length (in) | 13.66 |
Material | Cast Iron |
Mount Hole Diameter (in) | 0.586 in |
Mount Hole Diameter (mm) | 14.884 mm |
Nominal Brake Drum Diameter (in) | 11.15 in |
Nominal Brake Drum Diameter (mm) | 281.9 mm |
Programming Required | No |
Signs of Wear & Troubleshooting - Section 1 - Bullet 4 | Squealing or scraping noises. |
Signs of Wear & Troubleshooting - Section 1 - Bullet 5 | Brake pedal pulsation (not to be confused with normal ABS operation). |
Weight (lb) | 25 |
Width (in) | 13.66 |