×
close
click to zoom in

ACDelco 213-296 | Ignition Knock (Detonation) Sensor

(No reviews yet) Write a Review
$13.99
Part Number
ACD213-296
UPC:
36666168198
Condition:
New
5 customers are viewing this product

ACDelco GM Original Equipment Ignition Knock (Detonation) Sensors monitor the engine for pinging or spark knock, and are GM-recommended replacements for your vehicle's original components. These sensors create a voltage signal based on the vibrations caused by erratic air/fuel mixture combustion; the engine control module uses these signals to adjust the ignition timing and air/fuel mixture. These original equipment ignition knock sensors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors. ? WARNING: Cancer and Reproductive Harm - https://www.P65Warnings.ca.gov

BRAND: ACDelco

FEATURES:

  • Buick;Chevrolet;GMC;Oldsmobile;Pontiac
  • GM-recommended replacement part for your GM vehicle's original factory component
  • Helps prevent damage to the engine caused by pre-ignition
  • Manufactured to GM OE specification for fit, form, and function
  • Offering the quality, reliability, and durability of GM OE
  • Sends signals to the engine control module (ECM) to adjust timing

SPECIFICS:

Connector GenderFemale
Connector Quantity1
Connector ShapeRound
FAQ - Answer 1Yes. With a faulty sensor, there is a chance that higher emissions are being produced from the engine because the engine is running hot.
FAQ - Answer 2Yes. Knock is caused by pre-ignition or detonation. If left uncorrected, it can cause possible damage to the motor.
FAQ - Question 1Can a bad sensor cause the vehicle to run hot?
FAQ - Question 2Can engine knock damage an engine?
Good Maintenance Practices - Section 1 - Bullet 1Use approved octane fuel for your vehicle.
Good Maintenance Practices - Section 1 - Bullet 2Have vehicle serviced if 'Check Engine' light illuminates.
Height (in)1.6
Meets or Exceeds Original Equipment Manufacture SpecificationsYes
Mounting Hardware IncludedNo
Programming RequiredNo
Terminal Quantity1
Terminal TypeBlade Pin
Weight (lb)0.22
Width (in)2
Wire Harness IncludedNo

EXCEPT (RC9)

DOWNLOADS:

APPLICATIONS:

  • 1996-1996 Chevrolet Beretta
  • 1996-1999 Pontiac Grand Am
  • 1996-1997 Oldsmobile Achieva
  • 1997-1998 Chevrolet Malibu
  • 1996-1996 Oldsmobile Cutlass Ciera
  • 1996-1996 Chevrolet Corsica
  • 1996-1998 Buick Skylark
  • 1996-2002 Pontiac Sunfire
  • 1996-2002 Chevrolet Cavalier
  • 1996-1996 Buick Century
  • 1996-2003 GMC Sonoma
  • 1996-2003 Chevrolet S10

Product type:
Aftermarket
Product Description:
Ignition Knock (Detonation) Sensor
Mounting Hardware Included:
No
Terminal Type:
Blade Pin
Connector Gender:
Female
Terminal Quantity:
1
Connector Quantity:
1
Programming Required:
No
Connector Shape:
Round
Length (Inch):
2.9
Wire Harness Included:
No
Hazardous Material:
No
Minimum Order Quantity:
1
Features & Benefits - Bullet 2:
Helps prevent damage to the engine caused by pre-ignition
Features & Benefits - Bullet 4:
Offering the quality, reliability, and durability of GM OE
Features & Benefits - Bullet 3:
GM-recommended replacement part for your GM vehicle's original factory component
Features & Benefits - Bullet 1:
Sends signals to the engine control module (ECM) to adjust timing
Weight (lb) (Pound):
0.22
Height (in) (Inch):
1.6
Width (in) (Inch):
2
FAQ - Answer 2:
Yes. Knock is caused by pre-ignition or detonation. If left uncorrected, it can cause possible damage to the motor.
Life Cycle Status:
Announced
FAQ - Question 1:
Can a bad sensor cause the vehicle to run hot?
Life Cycle Status Description:
Announced - Part has been announced to customers on a paper “New Number Announcement”. Part is active.
FAQ - Question 2:
Can engine knock damage an engine?
Item Level GTIN:
00036666168198
Features & Benefits - Bullet 5:
Manufactured to GM OE specification for fit, form, and function
FAQ - Answer 1:
Yes. With a faulty sensor, there is a chance that higher emissions are being produced from the engine because the engine is running hot.
Good Maintenance Practices - Section 1 - Bullet 1:
Use approved octane fuel for your vehicle.
Good Maintenance Practices - Section 1 - Bullet 2:
Have vehicle serviced if 'Check Engine' light illuminates.
Length (Millimeter):
61.21
Meets or Exceeds Original Equipment Manufacture Sp:
Yes
Threaded End Diameter (Inch):
0.47
Threaded End Diameter (Millimeter):
12
Country of Origin:
United States
Weight - Each (Gross Pounds):
00.22
Height - Each (Inch):
01.60
Length - Each (Inch):
02.90
Width - Each (Inch):
02.00



Need help? We're available at1-321-400-8080 - Email us atinfo@partsonnet.net orlive help
to top