This bracket drag race stroker oil pan is for Small Block Chevy pre-?85 blocks with a two piece rear main. It is designed to fit most stock chassis. It has an 8" deep by 9-1/2" long sump and a 6 qt. system capacity. Clears a 4" stroke with a steel rod. Will work with stock or aftermarket starters. This pan requires one of our pickups.
| Baffled | Yes |
| Capacity | 6 Quart System Capacity |
| Crank Scraper Included | Yes |
| Dipstick Port | Yes |
| Drain Plug Included | Yes |
| Engine | For S.B. Chevy 1985 and earlier blocks |
| Feature 1 | Features Competition Oil Recovery System |
| Feature 2 | Removable Screen Windage Tray |
| Feature 3 | Built in Crank Scraper |
| Feature 4 | Trap Door Baffle For Oil Control |
| Feature 5 | Provision for Canton Pan Mounted Dipstick |
| Feature 6 | Magnetic Drain Plug |
| Finish | Silver Plating |
| Gasket or Seal Included | No |
| Hardware Included | Yes |
| Kicked Out | No |
| Material | 16 Gauge Steel |
| Pickup Included | No |
| Recommended Accessory 1 | 20-050 - Pickup for SBC Standard Volume Pumps M55 & M55A |
| Recommended Accessory 2 | 20-055 - Pickup for SBC Standard Volume Pump M155 w/ 3/4" Inlet |
| Recommended Accessory 3 | 20-080 - Pickup for SBC High Volume Pump M55HV |
| Recommended Accessory 4 | 20-081 - Bolt-On Pickup for Melling M10555 Pumps |
| Recommended Accessory 5 | 20-082 - Press-in Pickup for SBC High Volume Melling 10555 Pump |
| Recommended Accessory 6 | 20-085 - Pickup for SBC High Volume Pump M155HV w/ 3/4" Inlet |
| Stoke | 4.0 inches |
| Sump Depth | 8 inches |
| Sump Width | 7.5 inches |
| Windage Tray Included | Yes |
Canton
This pan is for GM LS1/LS6 powered cars that need a rear sump drag race oil pan and owners of 98+ F-Body chassis looking to install a GM LS1/LS6 engine in their car.BRAND: CantonFEATURES:Canton...
Canton
This Small Block Chevy "T" sump drag race oil pan is for pre-?80 blocks with a left side dipstick. It has a 7-1/2" deep, 9-1/2" long by 10-1/2" wide sump and an 7 qt system capacity. This pan...
Canton
This drag race oil pan is for BBC Mark 4 blocks. It has an 8" deep by 10" long and 11-3/4" wide sump and an 8qt. system capacity. Takes up to a 4.5" stroke with a steel rod. This pan requires our...
Canton
This BBC bracket drag oil pan is for Mark 4 blocks. It has a 9" deep by 9-1/2" long sump and a 7 qt. system capacity. Takes up to a 4.5" stroke with a steel rod. This pan requires our 20-190 pickup...
Canton
This bracket drag race oil pan is for Dart/Rocket aluminum and iron, spread rail blocks. It has an 8-1/4" deep by 9-1/2" long by 8-1/2" wide sump with a 6 qt. system capacity. Clears a 4.25" stroke...
