×
close

Cardone 19-B1732 | Front Left Disc Brake Caliper

(No reviews yet) Write a Review
$116.09
Part Number
CAD19-B1732
UPC:
82617678414
Condition:
New
5 customers are viewing this product

Expertly remanufactured to rigorous quality and performance standards, all CARDONE Brake Calipers are equipped with brand-new, premium components to guarantee exceptional longevity and reliability. These remanufactured brake calipers are 100% pressure-tested to deliver consistent, industry-leading brake performance. Each unit arrives with a complete set of brand-new hardware for a simple, complete installation. Caliper bracket is included when applicable.

BRAND: Cardone Reman

FEATURES:

  • Caliper, Brake Caliper, Disc Brake Caliper, Unloaded Caliper, Unloaded Brake Caliper, Power Brake Caliper, Hydraulic Disc Brake Caliper, Brakes
  • Reman. Unloaded Caliper w/Bracket
  • Remanufactured Unloaded Caliper w/Bracket
  • Unloaded Caliper w/Bracket
  • Volvo 850 1997-93, C70 2004-98, S70 2000-98, V70 2000-98

SPECIFICS:

Bleeder Port SizeM10x1.0
Brake Caliper FinishOil Emulsion
Caliper ColorGray
E-WasteNo
FAQsBrakes squeal all of the time. What's causing the squeal?
FAQsCould calipers be the cause of a low brake pedal?
FAQsNew hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.
FAQsBrake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
FAQsInspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation.
FAQsNot recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations.
FAQsCar pulls to one side during braking. Why?
FAQsA silicone grease is used on floating caliper mounting pins.
FAQsWhat type of fluid should I use: DOT 3, DOT 4, or DOT 5?
FAQsA symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder.
FAQsAs a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container.
FAQsCan I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
FAQsDo all of your Calipers come with the new hardware and a mounting bracket for installation?
FAQsWhat type of grease is used on floating caliper mounting pins?
Features and BenefitsA plastic cap plug protects every brake port thread to ensure trouble-free installation.
Features and BenefitsNew banjo bolts are included where applicable to ensure a perfect fit and quick installation.
Features and BenefitsCalipers are treated with a special formulated rust inhibitor and kept in the original equipment finish.
Features and BenefitsNew bleeder screws provide trouble-free bleeding and a positive seal.
Features and BenefitsPistons are durable, resistant to cracking or pitting and handle great loads.
Features and BenefitsAs a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
Features and BenefitsNew washers are included where applicable for a proper seal.
Features and BenefitsNew stainless steel hardware clips and new mounting pins are included where applicable.
Features and BenefitsMounting bracket is included where applicable for a hassle-free installation.
Features and BenefitsOur remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Features and BenefitsRubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
Inlet Port SizeM10x1.0
Installation Hardware IncludedYes
Mounting Bolts IncludedNo
Package ContentsCaliper; Bracket; Hardware Kit
Pads IncludedNo
Piston MaterialSteel
Piston Quantity1
Piston Size (OD) (mm)56.8706
Product ConditionRemanufactured

WARRANTY TIME: 24 Months

INTERCHANGE:

  • Volvo: 9200131
  • Volvo: 9173299
  • Volvo: 5003812
  • Volvo: 3516840
  • Volvo: 9157434
  • Volvo: 9485265
  • Volvo: 9142039

APPLICATIONS:

  • 1993-1997 Volvo 850 - Position: Front Left
  • 1998-2000 Volvo V70 - Position: Front Left
  • 1998-2000 Volvo S70 - Position: Front Left
  • 1998-2004 Volvo C70 - Position: Front Left

Product type:
Aftermarket
Features and Benefits:
Expertly remanufactured to rigorous quality and performance standards, all CARDONE Brake Calipers are equipped with brand-new, premium components to guarantee exceptional longevity and reliability. These remanufactured brake calipers are 100% pressur
Brand Description:
Brake Caliper
Hazardous Material:
No
Minimum Order Quantity:
1
Package Contents:
Caliper; Instruction Sheet; Bracket; Hardware Kit
Installation Hardware Included:
Yes
Product Condition:
Remanufactured
E-Waste:
No
FAQs:
Could calipers be the cause of a low brake pedal?
FAQs:
Car pulls to one side during braking. Why?
FAQs:
Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa?
FAQs:
Brakes squeal all of the time. What's causing the squeal?
FAQs:
Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish.
FAQs:
As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container.
FAQs:
A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder.
FAQs:
A silicone grease is used on floating caliper mounting pins.
FAQs:
What type of grease is used on floating caliper mounting pins?
FAQs:
What type of fluid should I use: DOT 3, DOT 4, or DOT 5?
FAQs:
Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations.
FAQs:
New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications.
FAQs:
Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation.
Life Cycle Status:
Available to Order
FAQs:
Do all of your Calipers come with the new hardware and a mounting bracket for installation?
Life Cycle Status Description:
Available to Order - Part is released to customers for ordering.
Features and Benefits:
Rubber seals are replaced with new high temperature EPDM rubber for extended life and optimum performance.
Item Level GTIN:
00082617678414
Features and Benefits:
Pistons are durable, resistant to cracking or pitting and handle great loads.
Quantity Per Application:
1
Features and Benefits:
Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Features and Benefits:
New washers are included where applicable for a proper seal.
Features and Benefits:
New stainless steel hardware clips and new mounting pins are included where applicable.
Features and Benefits:
New bleeder screws provide trouble-free bleeding and a positive seal.
Features and Benefits:
New banjo bolts are included where applicable to ensure a perfect fit and quick installation.
Features and Benefits:
Mounting bracket is included where applicable for a hassle-free installation.
Features and Benefits:
Calipers are treated with a special formulated rust inhibitor and kept in the original equipment finish.
Features and Benefits:
As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
Features and Benefits:
A plastic cap plug protects every brake port thread to ensure trouble-free installation.
Caliper Color:
Gray
Piston Quantity:
1
Piston Material:
Steel
Brake Caliper Finish:
Oil Emulsion
Pads Included:
No
Mounting Bolts Included:
No
Piston Size (OD) (mm):
56.87
Piston Size (OD) (in):
2.239
Mounting Type:
0.39
Bleeder Port Size:
M10x1.0
Short Description:
Caliper
Country of Origin:
United States
Weight - Each (Gross Pounds):
12.2000
Height - Each (Inch):
5.2500
Length - Each (Inch):
9.5620
Width - Each (Inch):
7.2500



Need help? We're available at1-321-400-8080 - Email us atinfo@partsonnet.net orlive help
to top