×
close
click to zoom in

Cardone 20-232 | Power Steering Pump

(No reviews yet) Write a Review
$95.39
Part Number
CAD20-232
UPC:
82617021395
Condition:
New
5 customers are viewing this product

CARDONE Remanufactured Power Steering Pumps are engineered to meet or exceed O.E. performance. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the original. All critical components are tested to ensure proper function. Every unit undergoes a hydraulic efficiency test to ensure reliable, long-lasting performance.

BRAND: Cardone Reman

FEATURES:

  • Ford Bronco 1977-72, Country Sedan 1974-67, Country Squire 1974-67, Custom 1972-67, Custom 500 1977-67, E-100 Econoline 1974-71, E-200 Econoline 1974-71, E-300 Econoline 1974-71, Elite 1976-75, F-100 1977-67, F-150 1977-75, F-250 1977-67, F-350 1977-67, F
  • Power Steering Pump
  • Power Steering Pump, Steering Pump, Pump and Reservior
  • Reman. Power Steering Pump
  • Remanufactured Power Steering Pump

SPECIFICS:

E-WasteNo
FAQsI only have assist when increasing engine rpm after installing the replacement pump. What's causing this?
FAQsI bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do?
FAQsYes. Some O.E. manufacturers recommend that power steering fluid be changed at 50,000 miles and continue at that interval. Just like engine oil, power steering fluid will eventually break down and carry suspended contaminants from component wear and breakdown. Follow your vehicle's O.E. manufacturer's recommendations on fluid change intervals.
FAQsA whining pump is usually caused by air in the power steering system. Inspect the reservoir for proper fluid level. If fluid has foam or air bubbles present, air has entered the system or has not been properly bled (ensure all hoses/clamps are tight). Some systems require special vacuum bleeding procedures.
FAQsWhy do I still have hard steering in one direction after I replaced the pump?
FAQsMost likely cause is contamination. Remove the pressure hose and pressure fitting on the power steering pump. Remove the flow control valve and spring. Clean the valve and check the valve bore for damage. Reinstall the spring, valve, fitting and hose. Flush and bleed system and re-test. If okay, install power steering filter to prevent problem from re-occurring.
FAQsThe pulley may have cracked upon removal. If the shaft was mushroomed before removing the pulley, it has now enlarged the bore in the pulley. The pulley must be replaced.
FAQsShould I ever change my fluid, even though nothing is wrong?
FAQsWhy is the pump making a whining noise all of the time?
FAQsThe problem is most likely in the steering unit-the pump does not know left from right. Check for binding steering components and repair as necessary.
Features and BenefitsShafts are surfaced to precise specifications to eliminate premature seal wear and extend pump life.
Features and BenefitsAll units are built with 100% new O-rings and premium-grade HNBR seals to prevent leaks. HNBR does not break down at high temperatures like conventional seal material.
Features and BenefitsAll critical components (cam packs, spool valves, etc.) are triple-tested to ensure product reliability.
Features and BenefitsFInal pump assembly is computer-tested to measure pressure, bypass, fluid flow, valve operation, steering effort and noise to ensure reliable performance.
Features and BenefitsAs a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
Features and BenefitsOur remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Features and BenefitsUnits are supplied with 100% tested and calibrated pressure relief valves.
Hose Port TypeSeat
Housing MaterialCast Iron
Mounting Hardware IncludedNo
Package ContentsHydraulic Pump; Instruction Sheet; Sealing Kit
Power Steering Outlet ID Size0
Power Steering Outlet Thread Size5/8-18
Power Steering Pump Inlet Attachement TypeHose Barb
Power Steering Pump Outlet Attachment TypeThreaded
Power Steering Pump Outlet Quantity1
Power Steering Reservoir Cap IncludedNo
Product ConditionRemanufactured
Pulley Attachement TypePress-On
Pulley IncludedNo
Remote ReservoirNo
Reservoir IncludedNo

APPLICATIONS:

  • 1967-1974 Ford Country Squire
  • 1967-1977 Mercury Marquis
  • 1967-1967 Mercury Marauder
  • 1967-1977 Ford F-350
  • 1967-1977 Ford LTD
  • 1975-1976 Ford Elite
  • 1967-1977 Ford F-100
  • 1967-1967 Ford Galaxie
  • 1975-1977 Mercury Bobcat
  • 1970-1971 Lincoln Continental
  • 1967-1968 Mercury Commuter
  • 1975-1977 Ford F-150
  • 1971-1976 Mercury Comet
  • 1974-1976 Ford Mustang II
  • 1970-1971 Lincoln Mark III
  • 1967-1974 Ford Galaxie 500
  • 1975-1977 Mercury Grand Marquis
  • 1967-1977 Mercury Cougar
  • 1968-1976 Mercury Montego
  • 1971-1974 Ford E-300 Econoline
  • 1967-1972 Ford Thunderbird
  • 1971-1974 Ford E-100 Econoline
  • 1967-1968 Mercury Park Lane
  • 1975-1977 Ford Pinto
  • 1976-1976 Ford Granada
  • 1972-1976 Ford Gran Torino
  • 1967-1969 Mercury Comet
  • 1967-1971 Mercury Cyclone
  • 1967-1972 Ford Custom
  • 1967-1974 Mercury Colony Park
  • 1967-1974 Mercury Monterey
  • 1969-1970 Mercury Marauder
  • 1977-1977 Ford LTD II
  • 1972-1977 Ford Bronco
  • 1970-1976 Ford Maverick
  • 1967-1968 Mercury Montclair
  • 1967-1974 Ford Country Sedan
  • 1967-1977 Ford Ranchero
  • 1967-1970 Ford Falcon
  • 1977-1977 Ford Thunderbird
  • 1967-1974 Ford Ranch Wagon
  • 1967-1970 Ford Fairlane
  • 1967-1973 Ford Mustang
  • 1968-1976 Ford Torino
  • 1976-1976 Mercury Monarch
  • 1971-1974 Ford E-200 Econoline
  • 1967-1977 Ford F-250
  • 1967-1977 Ford Custom 500

Product type:
Aftermarket
Features and Benefits:
CARDONE Remanufactured Power Steering Pumps are engineered to meet or exceed O.E. performance. Original designs are scrutinized for potential improvement, and where applicable, design upgrades are implemented to produce a more durable part than the o
Brand Description:
Power Steering Pump
Mounting Hardware Included:
No
Housing Material:
Cast Iron
Hazardous Material:
No
Minimum Order Quantity:
1
Reservoir Included:
No
Package Contents:
Hydraulic Pump; Instruction Sheet; Sealing Kit
Product Condition:
Remanufactured
E-Waste:
No
Pulley Included:
No
Power Steering Outlet Thread Size:
5/8-18
Hose Port Type:
Seat
Remote Reservoir:
No
FAQs:
Why is the pump making a whining noise all of the time?
FAQs:
Why do I still have hard steering in one direction after I replaced the pump?
FAQs:
The problem is not in the pump, it is in the steering gear. The pump would cause a steering problem in both directions.
FAQs:
The end of the original pump's input shaft enlarged causing the pulley hole to increase during removal. The pulley must be replaced.
FAQs:
Should I ever change my fluid, even though nothing is wrong?
FAQs:
I only have assist when increasing engine rpm after installing the replacement pump. What's causing this?
FAQs:
I bought a replacement power steering pump and my original pulley has a loose fit on the replacement pump shaft. What should I do?
Life Cycle Status:
Available to Order
Features and Benefits:
Units are supplied with 100% tested and calibrated pressure relief valves.
Life Cycle Status Description:
Available to Order - Part is released to customers for ordering.
Features and Benefits:
Shafts are surfaced to precise specifications to eliminate premature seal wear and extend pump life.
Item Level GTIN:
00082617021395
Features and Benefits:
Our remanufacturing process is earth-friendly, as it reduces the energy and raw material needed to make a new part by 80%.
Quantity Per Application:
1
Features and Benefits:
FInal pump assembly is computer-tested to measure pressure, bypass, fluid flow, valve operation, steering effort and noise to ensure reliable performance.
Features and Benefits:
As a remanufactured Original Equipment part, this unit guarantees a perfect vehicle fit.
Features and Benefits:
All units are built with 100% new O-rings and premium-grade HNBR seals to prevent leaks. HNBR does not break down at high temperatures like conventional seal material.
Features and Benefits:
All critical components (cam packs, spool valves, etc.) are triple-tested to ensure product reliability.
Pulley Attachement Type:
Press-On
Power Steering Reservoir Cap Included:
No
Power Steering Pump Inlet Attachement Type:
Barb
Power Steering Pump Outlet Attachment Type:
Threaded
Power Steering Pump Outlet Quantity:
1
Short Description:
Pwr Steering Pump
Country of Origin:
Mexico
Weight - Each (Gross Pounds):
10.2100
Height - Each (Inch):
7.8750
Length - Each (Inch):
5.7500
Width - Each (Inch):
5.6250



Need help? We're available at1-321-400-8080 - Email us atinfo@partsonnet.net orlive help
to top