Edelbrock part #28002 Big Victor 2 Spread-Port Tall-Deck intake manifold is designed for large cubic-inch or high rpm drag racing big-blocks with Edelbrock Big Victor, Dart Big Chief or Brodix Big Duke cylinder heads, this manifold has an average runner area of approximately 4.75 sq. in. The port exits have been reduced to accommodate the wide variety of intake port sizes and require port matching. The runners have a minimum corner radius of .500" from the plenum to the exit allowing the popular oval port shape to be used. The outside runners are shorter and straighter than competitor's manifolds and the plenum is longer Front to back. These features, combined with approximately 5% taper in runner cross-sectional area, give better top end horsepower while maintaining consistency and throttle response off the stop. All applications are equipped with a 4500 Series flange and will accept 2.25" throttle body butterflies without a spacer or modification.
| Cylinder Head Type | Big Chief |
| Emission | Without EGR |
| Engine Make/Size | Chevy Big Block (396-502) |
| Number of Carbs | One |
| Position | N/A |
| RPM Range | 3500-8500 |
| Usage | Racing |
| WARNING CA Proposition 65 | Yes |
| WARNING CA Proposition 65 Message | WARNING: This product can expose you to Lead; which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information; visit www.P65warnings.ca.gov. |
Edelbrock
Edelbrock part #7521 RPM Air-Gap intake manifold is designed for street 289 302-347 c.i.d. Ford V8 applications. The RPM Air-Gap incorporates the same race-winning technology that's been used on our...
Edelbrock
Edelbrock part #27013 Performer EPS intake manifold is designed for 1986 and earlier 262-400 cubic-inch Chevys. Edelbrock's Patented Dual-plane, low-rise design with a 180-degree firing order greatly...
Edelbrock
Edelbrock part #7525 RPM Air-Gap dual-quad intake manifold is designed for 1955-86 S/B Chevys, this intake stands 1-5/8" taller than the low-profile C-26 intake and offers performance improvements in...
Edelbrock
Edelbrock part #5056 Torker II 460 intake manifold is designed for 429/460 c.i.d. Ford V8's used in marine and high performance applications. Manifold not equipped with EGR. Will fit 429 Cobra-Jets...
Edelbrock
Edelbrock part #2716 Performer EPS Vortec intake manifold is now available for small-block Chevys with Vortec or Edelbrock E-Tec cylinder heads, the Performer EPS dual-plane manifold is optimized to...
