The Edelbrock 90mm single bore throttle body is intended for Pro-Flo XT and EFI Victor Elbow applications. It has provisions for either LS1 or LS2 mounting bolt patterns. The throttle body uses LS1 style TPS and IAC. It offers better idle control than other 90mm throttle bodies, because of the addition of an idle bleed screw. By using the bleed screw to create a base amount of idle air flow instead of throttle tip-in, the TPS signal is unaffected. Features a 4.5" Inlet. Satin Finish
| WARNING CA Proposition 65 | Yes |
| WARNING CA Proposition 65 Message | WARNING: This product can expose you to Lead; which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information; visit www.P65warnings.ca.gov. |
Edelbrock
The Edelbrock 90mm single bore throttle body is intended for Pro-Flo XT and EFI Victor Elbow applications. It has provisions for either LS1 or LS2 mounting bolt patterns. The throttle body uses LS1...
Edelbrock
The Edelbrock #3878 Victor EFI 4-Barrel Throttle Body complements our Victor EFI line of manifolds. This throttle body mounts on a standard 4150-style square-bore carburetor bolt spacing. It is sand...
Edelbrock
The Edelbrock 2737 Throttle Body Adaptor is an 80mm LS1 to 90mm Elbow. This thin plate is similar in design to our 2732 carburetor adaptor plate. It's needed because the large 90mm opening on our...
Edelbrock
Larger-than-stock throttle bodies deliver increased performance by allowing more air to enter the engine. The Edelbrock 103mm Throttle Body #38989 features digital electronics and is designed for use...
Edelbrock
The Edelbrock #3813 replacement throttle body flange gasket is for all Pro-Flo XT systems and Edelbrock #3869 90mm throttle bodyBRAND: EdelbrockFEATURES:Throttle Body Replacement Gasket SetDirect...
