GM Genuine Parts
GM Genuine Parts D6346E | Washer Fluid Level Sensor
APPLICATIONS:2010-2016 Cadillac SRX2011-2011 Saab 9-4X
GM Genuine Parts Windshield Wiper Arm/Motor Assembly are designed, engineered, and tested to rigorous standards, and are backed by General Motors. These components sense the amount of washer fluid in the reservoir and sends a signal to the warning light on the dash to alert the operator of low fluid levels. GM Genuine Parts are the true OE parts installed during the production of or validated by General Motors for GM vehicles. Some GM Genuine Parts may have formerly appeared as ACDelco GM Original Equipment (OE). ⚠
Color | Black |
Connector Color | Black |
FAQ - Answer 1 | No if this happens clean the sensor connections or replace the sensor. |
FAQ - Answer 2 | It is best to use GM approved fluid to prevent that possibility. |
FAQ - Answer 3 | Most winter washer fluids contain methanol to lower the freezing point but in extreme cold temperatures it is possible. |
FAQ - Question 1 | Should the low fluid light come on when the reservoir is full? |
FAQ - Question 2 | Will using non-approved fluid cause damage to the sensor? |
FAQ - Question 3 | Can washer fluid freeze? |
Gasket Or Seal Included | Yes |
Good Maintenance Practices - Section 1 - Bullet 1 | Before the purchase and installation of a washer fluid level sensor, make sure it is the correct fit for your vehicle. |
Good Maintenance Practices - Section 1 - Bullet 2 | Use approved washer fluid |
Good Maintenance Practices - Section 1 - Bullet 3 | Keep sensor wire harness free from damage by contact wear |
Good Maintenance Practices - Section 1 - Bullet 4 | Replace sensor or seal at first sign of leaks |
Good Maintenance Practices - Section 1 - Bullet 5 | Regularly inspect the fluid level sensor are and the park ramp for signs of damage or wear and replace them if signs of damage are found |
Height (in) | 1.48 |
Height (mm) | 37.61 |
Length (in) | 2.7 |
Length (mm) | 68.64 |
Programming Required | No |
Signs of Wear & Troubleshooting - Section 1 - Bullet 1 | Low washer fluid light not illuminating |
Signs of Wear & Troubleshooting - Section 1 - Bullet 2 | Low washer fluid light stays on |
Signs of Wear & Troubleshooting - Section 1 - Header | Signs of wear or damage for the washer fluid level sensor include but are not limited to: |
Width (in) | 1.55 |
Width (mm) | 39.43 |