Ever wonder how you can install an aftermarket tachometer on a vehicle with no distributor and multiple coil packs? MSD has the answer with the distributorless tach driver. The compact tach driver measures only 1.5 x 3.5 x 2 inches and is potted with a polyurethane compound for vibration and water protection so it can easily be mounted under the hood. It wires inline on the coils' 12 volt supply wire where it senses the current going through this wire and converts this information into a 12 volt output signal that most aftermarket tachometers use as a trigger signal. It can be used on 4, 6 or 8 cylinder engines.
| WARNING CA Proposition 65 | Yes |
| WARNING CA Proposition 65 Message | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov |
MSD
MSD Ignition is a company built on Customer Satisfaction and Service. That is why all of MSD products go through regimented test procedures before they are ever packaged and shipped. MSD stands...
MSD
If you are running a dual ignition system, this little device will allow the tachometer to operate with both ignitions. Simply install the splitter between the tach outputs and the tachometer. Female...
MSD
The standard tach drive for MSD tach drive distributors is a 3/16 inch tang drive cable. In most cases this type of drive will work, but for those who require the 0.104 inch square drive (Corvette...
MSD
The magnetic signal stabilizer converts the signal from a magnetic pickup to a square wave trigger signal for the MSD control.BRAND: MSDFEATURES:Magnetic Signal Stabilizer; Square Wave Trigger Signal...
