24/7 Customer Service
Just think of the things you can easily accomplish with our GMR pickup! This little device simply attaches, with no splicing or cutting, to a current carrying wire and turns that information into a 12 Volt RPM signal. This signal can be used to activate a shift light, RPM activation switch or a tachometer. One example is to connect the GMR, which stands for giant Electro-Magnetic, to a diesel injector current wire. This will produce a signal that can be used to trigger a tachometer or shift light! Another example is on late-model engine equipped with a coil-on-plug ignition system. One of the coil's primary current wires is simply routed into the pickup clip and GMR converts this pulsing into a 12 Volt signal for a shift light!
| WARNING CA Proposition 65 | Yes |
| WARNING CA Proposition 65 Message | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov |
MSD
The magnetic signal stabilizer converts the signal from a magnetic pickup to a square wave trigger signal for the MSD control.BRAND: MSDFEATURES:Magnetic Signal Stabilizer; Square Wave Trigger Signal...
AutoMeter
This fully potted, weatherproof module can be wired to ground / kill switch terminal magneto ignition systems to provide a conventional 12V square wave signal which can be utilized by AutoMeter...
MSD
If, after installing an MSD ignition control, your tachometer, fuel pump relay or electronic fuel injection (in foreign vehicles) doesn't operate correctly, your application may require a tach...
MSD
The standard tach drive for MSD tach drive distributors is a 3/16 inch tang drive cable. In most cases this type of drive will work, but for those who require the 0.104 inch square drive (Corvette...
