MSD
MSD 86201 | Ignition Crank Trigger Kit
The MSD Flying Magnet Crank trigger is now available with a Hall-Effect sensor making it the most accurate way to trigger your EFI. The kit installs easily and uses rigid aluminum mounting bracketry...
When you install a crank trigger system, having locked out timing may put a strain on the starter and flywheel. This compact controller provides a retard that automatically retards the timing during cranking to ease the pressure. The MSD starter saver measures only 1.5 X 3.5 X 2 inches and wires into your ignition system with only four wires. It can be programmed to retard the timing 10 or 20 degrees during cranking only. The retard is activated when the engine begins cranking and is deactivated once the engine reaches over 800 rpm. (If the engine rpm drops below 500 rpm it will activate again.) The starter saver receives the trigger signal through an MSD crank trigger pick-up or the distributor's magnetic pick-up. This control has a very accurate pick-up compensation circuit resulting in rock steady timing throughout the entire rpm range of your engine. There is also an LED that illuminates with each trigger signal to confirm operation and the circuitry is completely potted in a polyurethane compound for extreme vibration resistance.
WARNING CA Proposition 65 | Yes |
WARNING CA Proposition 65 Message | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov |