3/4 round, Amber lens LED lamp for use as a combination turn signal and running lamp, for use with Poison Spyder Customs DeFenders, Tube Fenders, Crusher Flares, or anywhere youd like to mount them by drilling a 3/4 hole in a flat panel. This is a 3-WIRE assembly, meaning it can be used as both a turn signal AND a marker lamp simultaneously. It can also be used as only a marker lamp (or only a turn signal) by using two wires and leaving the third wire unused. These high quality LED lamps are DOT-approved for use on your vehicle. Includes pigtail harness and mounting grommet. This item is available in red.
| WARNING CA Proposition 65 | Yes |
| WARNING CA Proposition 65 Message | WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov. |
Poison Spyder
This resistor assembly equalizes the current load for proper function of LED taillights with the Jeep JKs electrical system. It easily installs inline in your taillight wiring. One is needed for each...
Poison Spyder
These 24-diode LED taillights easily install using a rubber grommet—they simply push into place. This is a 4 round light (requires a 4-1/2 hole) with red lens. Flush-mount LED taillights stay out of...
Poison Spyder
This rectangular LED Marker Lamp is the solution for those who need to run a combination marker lamp and turn signal in the same unit. This may be necessary on Jeeps where the OE turn signals and/or...
Poison Spyder
2-1/2 flush mount LED back-up light for use with Poison Spyder Customs Crusher Corners, Trail Corners or any other manufacturers corner protectors, or anywhere you can cut a 2-3/4 hole in a flat...
Poison Spyder
Electronic flasher to provide proper current intermittency for LED taillights and turn signals in your Jeep 1997-2000 Jeep TJ. Easy to install (instructions included).BRAND: Poison...
