Ready to bolt on control arm sets for your 63-76 A-Body Mopar. They feature tubular construction, black powder coat and polyurethane inner pivot bushings. Stronger than the factory control arms without adding any weight, these upper control arms increase caster by approximately 3 degrees. Each set comes with ball joints. Made in the USA. This part is only for factory cars and any A-Body that was swapped to disc brakes with factory parts (large ball joint).
| California Proposition 65 | WARNING: Cancer and Reproductive Harm. www.P65Warnings.ca.gov |
| Title | QA1 Suspension Control Arm Kit 52301 |
QA1
Want to use a factory style spring with the shock in the factory location of your 1963-1987 C10? QA1 offers front lower control arms for use with stock springs. The arms are made with 12 gauge HSLA...
QA1
QA1 offers control arms for your 62-77 Mopar B-body or 70-74 Mopar E-body with sway bar tabs. These lower control arms are a direct bolt-in on your factory k-member and are twice as strong as factory...
QA1
Ready to bolt on control arm sets for your 64-72 A-Body Mopar. They feature tubular construction, black powder coat and polyurethane inner pivot bushings. Stronger than the factory control arms...
QA1
QA1 upper control arms for 1963-1987 C10s work with the stock springs or with a coil-over conversion. They are made with 12 gauge HSLA steel for increased strength and are powder coated for...
QA1
These hardware kits for control arms replace factory hardware with 4 new bolts, A/N washers and nylock nuts. Made in the USA.BRAND: QA1FEATURES:Hardware Kit, Lower Control Arm Gm, 64-72 A, G & F,...
