Change camber,caster, or both on twin traction beam Dana 44s with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve puller, remove the existing sleeve. Unstall zero degree sleeve 23109 to determine the change needed, then install the correct sleeve. To split camber and caster adjustment, rotate sleeve 45°.
| California Proposition 65 | WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. |
WARNINGThis product can expose you to chemicals, including WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
SPC Performance
Ford changed the axle design in 2005 on their Heavy Duty trucks. These sleeves correct camber and caster on these F250 and F350 Super Duty trucks. Use the 23229 zero degree sleeve to determine the...
SPC Performance
These truck sleeve will correct alignment problems on the F450 and F550 Super Duty trucks with Dana Super 60 solid axles. To split camber and caster adjustment, rotate sleeve 45° Use the 23239 zero...
SPC Performance
These truck sleeve will correct alignment problems on the F450 and F550 Super Duty trucks with Dana Super 60 solid axles. To split camber and caster adjustment, rotate sleeve 45° Use the 23239 zero...
SPC Performance
Required: 1 per wheel This sleeve changes camber and caster on many older model trucks and SUVs with Dana 44 or GMC 10 bolt axles. 4169 spanner socket is required for removal. Rotate sleeve to fine...
SPC Performance
Change camber,caster or both at the same time with these sleeves. Simply remove the tire, cotter pin and upper ball joint stud nut and break the taper free between the stud and sleeve. Using a sleeve...
