These adapter sleeves are designed to be used with the 40920 Performance Ball Joint Press. It is designed specifically to remove the stock rear control arm bushings and to install our Offset Rear Camber Bushings, Part number 66050 used on the new Chrysler LX platform cars.
| California Proposition 65 | WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. |
WARNINGThis product can expose you to chemicals, including WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
SPC Performance
Service a wide range of bushings with this versatile press set. Our 29 piece kit will allow you to efficiently remove and install bushings from 1 1/2" to 3" OD (36-80mm ). Save time by servicing the...
SPC Performance
The OE rear toe link bushing on many Subarus and the Scion FR-S can be easily removed when using the 67647 Bushing Press Adapter. Our Eccentric Toe Bushings (part# 67660) can then be installed using...
SPC Performance
This proprietary SpecRide Bushing Replacement Kit provides superior performance and durability for your 25465/25490 Toyota Adjustable Control arms. Each kit contains 4 SpecRide bushings with free...
SPC Performance
Replace your balljoint boots on several popular upper control arms. This kit includes 2 ball joint boots and 2 retaining rings.BRAND: Specialty ProductsFEATURES:BOOT REPLACEMENT...
SPC Performance
This proprietary SpecRide Bushing Replacement Kit provides superior performance and durability for your 25485 Toyota Adjustable Control arms. Each kit contains 4 SpecRide bushings with free moving...
SPC Performance
Replace the xAxis bushings on your control arms using this kit from SPC. This kit includes enough xAxis bushings to service two control arms and includes a press tool. Note that you will need access...
