Get your GM truck or SUV's front camber or caster back in spec with these fixed offset upper control arms. Whether you lift your rig 3" or lower it 1" it is going to lose caster. The OE adjusters do not provide enough change, so install SPC offset arms for +2° caster change and then use the OE cams to dial your alignment in and get your drivability back. These arms feature: *Fully forged contruction for maximum strength. *Booted and greasable ball joints that will last for the life of your truck. *SPC's xAxis technology with a twist. The xAxis sealed flext joints used in these arms provide a free pivot for droop and misalignment that OE caster and camber adjustments will not bind the joint. These cross axis ball joints alsohave rubber isolation to retain OE bushing values for Noise, Vibration, and Harshness (NVH). Kit includes arms for both the right and left hand side. It can be used for lifted and lowered applications, if you drop your ride height more than 1" it will start to gain caster very quickly. These arms will still work for you, swap these arms left to right and get -2° caster change if you need it. Need to replace the OE adjusters? Consider SPC's p/n 86375 replacement cams, p/n 86325 replacement alignment pins and p/n 86320 alignment locking plates.
| California Proposition 65 | WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. |
WARNINGThis product can expose you to chemicals, including WARNING: This product contains chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
SPC Performance
Adjust front camber and caster ±1.5° on the Audi B9 platform with these forged aluminum adjustable control arms from SPC. OE style booted ball joints and bonded rubber bushings maintain factory ride,...
SPC Performance
links Replacement pinch bolts included xAxis sealed flex joints replacing overly compliant OE inner bushings with a free pivoting, minimum compliance joint. Warning: You will also hear the...
SPC Performance
Improve droop travel, drivability and tire wear as well as adjusting tire position in your wheel well with SPC's adjustable front upper control arms. Featuring an upgraded greasable ball joint and...
SPC Performance
Use this patented design with the most adjustability and best clearance of any arm on the market to modernize the front suspension on your classic Mopar. SPC uses a 1/2" extended ball stud to improve...
SPC Performance
Give your 1965-70 Impala, Bel Air, Caprice, or Biscayne a more modern alignment set-up with SPC's adjustable front upper control arm. This highly adjustable A-arm provides ±3° of caster and ±3° of...
