ACDelco
ACDelco 17904R | Rear Drum Brake Shoe
ACDelco (Professional) Gold Riveted Brake Shoes are the high quality alternative to Original Equipment (OE) parts. Engineered with a premium dipped coating to help resist corrosion and premature...
Drum Inside Diameter (in) | 7.87 |
FAQ - Answer 1 | Yes, ACDelco Professional Brake Shoes come with a limited lifetime warranty. |
FAQ - Answer 2 | No, but it is a good idea to inspect them for wear-out, cracking, leaking etc. |
FAQ - Answer 3 | Yes, ACDelco also offers GM OE brake pads and Advantage Brake Shoes. |
FAQ - Answer 4 | No, but it is a good idea to inspect your brake shoes at each tire rotation. |
FAQ - Question 1 | Are these brake parts durable? |
FAQ - Question 2 | Do I have to replace all my brake parts when replacing my brake shoes? |
FAQ - Question 3 | Does ACDelco offer other grades of brake shoes? |
FAQ - Question 4 | Do I have to replace my brake shoes after a certain amount of time? |
Friction Material Attachment | Bonded |
Good Maintenance Practices - Section 1 - Bullet 1 | Check brake fluid level at every oil change. Replace fluid according to owner's manual recommendations. |
Good Maintenance Practices - Section 1 - Bullet 2 | Calipers and wheel cylinders should be checked every brake inspection and serviced or replaced as required. |
Good Maintenance Practices - Section 1 - Bullet 3 | Inspect the brake lines for rust, punctures, or visible leaks (You may be able to do this, but consult a qualified technician if necessary). |
Good Maintenance Practices - Section 1 - Bullet 4 | Check the thickness of your brake pads. |
Good Maintenance Practices - Section 1 - Header | The following inspections and maintenance procedures can help prevent potential brake problems: |
Good Maintenance Practices - Section 2 - Bullet 1 | Inspection of the brake hoses for brittleness or cracking. |
Good Maintenance Practices - Section 2 - Bullet 2 | Inspection of brake lining and pads for wear or contamination by brake fluid or grease. |
Good Maintenance Practices - Section 2 - Bullet 3 | Inspection of wheel bearings and grease seals. |
Good Maintenance Practices - Section 2 - Bullet 4 | Parking brake adjustments (as needed). |
Good Maintenance Practices - Section 2 - Header | The following should be conducted by a qualified technician: |
Height (in) | 3.62 |
Length (in) | 9.5 |
Mounting Hardware Included | No |
Programming Required | No |
Signs of Wear & Troubleshooting - Section 1 - Bullet 4 | Vehicle pulls to the left or right when brakes are applied. |
Weight (lb) | 2.16 |
Width (in) | 8.12 |