SPC Performance

Adjust camber and caster for maximum handling and performance with our adjustable arms for Corvettes, Impalas and 'Tri-5' Bodies. Arms include a steel cross shaft with street style or race pivots and...

Adjust camber and caster for maximum handling and performance with our adjustable arms for Corvettes, Impalas and 'Tri-5' Bodies. Arms include a steel cross shaft with street style or race pivots and...

These rear arms provide an increased amount of camber change on these popular tuner cars. Two arms are required per side and are adjusted together to give the maximum amount of camber change without...

This replacement front adjustable strut rod is easily adjustable and gives these popular tuner vehicles the ability to change caster by 3deg. A stiffer rubber bushing material provides better...

This adjustable arm increases the amount rear toe can be changed on this popular performance vehicle. It is recommended that this arm be installed when either the 67765 or 67775/67776 is being...

Used on any brake lathe and with any ventilated rotor, they suppress vibration and noise. Segmented silencer is made of the finest latex rubber tubing with four (4) steel tubes to quiet chatter...

These 8" steel adjusting sleeves are the perfect fit with our pivot studs and ball joint plates. California Residents WARNING

These adjustable upper ball joints make front camber adjustments for many vehicles with upper control arms. By replacing the factory ball joint, this sliding ball joint allows for greater changes...

Able to change camber from +1.50deg up to +3.0deg these ball joints are perfect for lowered vehicles. For changes less than +1.5deg check out our Adjustable Ball Joints. These ball joints have the...

These arms correct rear camber on stock ride height vehicles and vehicles that have been lowered up to 1.5" with an adjustment range of -2.0deg to +3.5deg. 67065 comes with a non-directional ball...

These arms correct rear camber on vehicles that have been lowered up to 3.0" with an adjustment range of -2.0deg to +3.5deg. The "bent" design of the arm gives extra clearance. The 67265 comes with a...

This pair of rear lower control arms are direct replacements for weak or bent factory units on the 80 series Landcruiser. Made of 3/16" wall DOM tube, they are more than 2x stronger than the OEM...

These adjustable upper ball joints make front camber adjustments for many vehicles with upper control arms. By replacing the factory ball joint, this sliding ball joint allows for greater changes...

Able to change camber from +1.50deg up to +3.0deg these ball joints are perfect for lowered vehicles. For changes less than +1.5deg check out our Adjustable Ball Joints. These ball joints have the...

This OE style ball joint is a press in replacement for many Honda and Acura front upper control arms. Ball joints are fully sealed, and the coating provide superior corrosion protection from the...