ACDelco
ACDelco 337-1002 | Starter Motor
StarterBRAND: ACDelcoSPECIFICS:ACD_RemanDesNoAltPA_262_HP3.35AltPA_262_KW2.50AltPA_265_mm270.4AltPA_266_mm20.
Case Grounding | Grounded Case |
Family | Permanent Magnet Planetary Gear Reduction |
FAQ - Answer 3 | Is the solenoid included? |
FAQ - Answer 4 | Can I be assured that the unit will last, especially in extreme weather? |
FAQ - Answer 5 | Do I always need a starter shim? |
FAQ - Question 4 | Yes. It is included where the design of the starter requires a solenoid. |
FAQ - Question 5 | Yes. These starters are designed to withstand a wide range of weather conditions. |
FAQ - Question 6 | No. However a shim may be required at the starter's mounting surface to align the starter, so the starter drive makes appropriate contact with the flywheel. |
Good Maintenance Practices - Section 1 - Bullet 6 | Check electrical connections, making sure they are kept clean. |
Good Maintenance Practices - Section 1 - Bullet 7 | Make sure all connections to the battery are firmly attached and in good condition. |
Good Maintenance Practices - Section 1 - Bullet 8 | Keeping all connections clean and tight will make sure your starter will crank with full power. |
Good Maintenance Practices - Section 1 - Bullet 9 | It is very important to try and keep the starter area clean from leaking car fluids or any other debris that may be near it. |
Height (in) | 5.8 |
Length (in) | 12.7 |
Meets or Exceeds Original Equipment Manufacture Specifications | Yes |
Mounting Bolt Hole Quantity | 2 |
Mounting Hardware Included | No |
Mounting Shims Included | No |
Nose Cone Material | Aluminum |
Nose Cone Type | Closed Nose |
Programming Required | No |
Re Clockable Flange | No |
Signs of Wear & Troubleshooting - Section 1 - Bullet 5 | Indicators that there could be a problem with your vehicle's starter are: |
Signs of Wear & Troubleshooting - Section 1 - Bullet 6 | Engine will not crank |
Signs of Wear & Troubleshooting - Section 1 - Bullet 7 | Engine cranks slowly |
Signs of Wear & Troubleshooting - Section 1 - Bullet 8 | Clunking/grinding noise when starting engine |
Signs of Wear & Troubleshooting - Section 1 - Bullet 9 | Starter will not engage |
Signs of Wear & Troubleshooting - Section 2 - Bullet 5 | Other vehicle parts that might cause related starter problems include: |
Signs of Wear & Troubleshooting - Section 2 - Bullet 6 | Electrical fault |
Signs of Wear & Troubleshooting - Section 2 - Bullet 7 | Loose mounting bolts |
Signs of Wear & Troubleshooting - Section 2 - Bullet 8 | Sticking starter drive |
Signs of Wear & Troubleshooting - Section 2 - Bullet 9 | Damage to flywheel |
Solenoid Attached | Yes |
Starter Rotation | Clockwise |
Tooth Quantity | 9 |
Voltage | 12 VDC |
Weight (lb) | 7.8 |
Width (in) | 7.2 |