Camburg

These are the same brake lines we use in our performance kits. They are extended in length, Teflon-lined, stainless steel braided and Kevlar reinforced with an additional protective covering. Our...

The stock inner tie-rod ball-joint joint on the 1998-2012 Rangers is known for failing under off-road conditions, so we came up with a solution for this problem. The steering clevis is CNC machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These are the brake caliper tabs we use when building a Camburg rear end. These are designed for Wilwood's 3.5" lug spacing. They also work with radial mount calipers with the proper machined...

These rotor adapters/hats are designed for our 2.0 front race hubs. We CNC machine them in-house from 6061-T6 aluminum, then Type II anodize them matte black. We offer these in two versions to offset...

These rotor adapters/hats are designed for our 2.0 front race hubs. We CNC machine them in-house from 6061-T6 aluminum, then Type II anodize them matte black. We offer these in two versions to offset...

These rotor adapters/hats are designed for our 2.0 front race hubs. We CNC machine them in-house from 6061-T6 aluminum, then Type II anodize them matte black. We offer these in two versions to offset...

These rotor adapters/hats are designed for our 2.0 front race hubs. We CNC machine them in-house from 6061-T6 aluminum, then Type II anodize them matte black. We offer these in two versions to offset...